PrintWolves
Back
Designdesigntolerancesoverhangscad

Designing Parts for 3D Printing: Overhangs, Clearances and Holes

By Arun Sai Prakash S P · 15 October 2026 · 4 min read

Contents7 sections

A design that works perfectly in CAD can still print badly. 3D printers build parts one layer at a time, and that one fact explains almost every rule below. Follow them and your parts print cleaner, fit first time and cost less.

Overhangs: the 45 degree rule

Each layer has to sit on the one below it. A slope up to about 45 degrees from vertical prints cleanly, because each layer is mostly supported. Beyond that, the plastic is printed into thin air and needs support material.

Ways to avoid supports:

  • Chamfer instead of a flat ledge. A 45 degree chamfer under a shelf prints on its own. A flat ledge needs supports.
  • Teardrop holes. A round horizontal hole has a flat roof at the top. Making the top a point (a teardrop shape) lets it print without support.
  • Short bridges are fine. Printers can span short flat gaps between two supports. Keep unsupported bridges short.

Clearances for parts that fit together

Printed parts are never exactly the size in the file. Plastic squishes slightly, and every printer and material behaves a little differently. Design gaps between mating parts as a starting point:

FitGap between surfaces
Press fit (parts held by friction)about 0.2 mm
Sliding fit (lids, drawers)about 0.3 to 0.4 mm
Free moving parts (hinges, gears)0.4 mm or more

Holes come out small

On FDM printers, vertical holes usually come out slightly undersized. If a bolt or pin must pass through, design the hole a little larger (adding 0.2 to 0.3 mm to the diameter is a good start), or plan to drill it out to size.

For holes that must be accurate, such as bearing seats, design them slightly small and ream or drill them to the exact size after printing.

Walls and small features

  • Minimum wall thickness: around 0.8 mm for decorative parts, 1.2 mm or more for functional ones.
  • Make walls a multiple of the nozzle width. With a standard 0.4 mm nozzle, walls of 0.8, 1.2 or 1.6 mm print as solid lines with no weak gap in the middle.
  • Raised text: keep strokes at least 0.5 mm wide and 0.5 mm high, or it may not print at all.

Strength depends on direction

A printed part is strongest along its layers and weakest between them, because layers can split apart. A hook printed standing up will snap along a layer line much sooner than the same hook printed lying flat.

When you design a load-bearing part, think about which way the force pulls, and tell us. We orient the part so the force runs along the layers, not across them.

Screws and threads

Screwing straight into plastic works a few times, then the thread wears out. For parts that are opened and closed:

  • Use heat-set brass inserts. They are melted into the plastic and give a real metal thread.
  • Or design a hexagonal pocket for a nut on the back of the part.

Leave enough solid material around the insert. A pillar about twice the diameter of the insert is a safe starting point.

Quick checklist

  • No overhangs steeper than 45 degrees without chamfers or a plan for supports
  • Clearances designed in for every moving or mating part
  • Holes sized up, or planned for drilling
  • Walls at least 1.2 mm on functional parts
  • Load direction considered and noted in your enquiry
  • Inserts or nut pockets instead of screwing into plastic

Not sure your design is printable? Our engineers check every file before printing, and our 3D modelling service can adjust a design for you.

Continue Reading